Operating Manual DTT 6801 Multicontroller (MC) 086100037 © Pfannenberg GmbH Page 17 / 49
3 Assembly and initial commissioning
3.1 Transport
Danger due to uncontrolled movements
Improper securing of the unit can result in severe accidents.
Loading must only be carried out by trained, qualified personnel.
Lash the unit correctly for transport on a truck or trailer.
Only use lashing straps with an adequate rated strength.
Use slip-resistant materials for securing, e.g. anti-slip mats.
When loading by crane, do not walk or stand under the raised units.
Danger of material damage during transport and setting down of the units.
Improper device securing or uncontrolled movements can cause damage.
Exercise maximum caution during movement and transport of the units.
Always transport the unit in the position of use.
Transport of the cooling units must always take place with the packaging provided at the factory. It comprises an
outer carton, bottom plate and base and top cushions.
Transporting cooling units
Requirements
- Cooling unit are in the packaging provided by the factory.
Required tools and material
- Lashing straps, loading crane, if applicable
Procedure
Secure correctly for transport with lashing straps. Always transport in the position of use.
Always raise cooling units by the housing.
Always raise cooling units slowly and evenly and set down safely.
The cooling units was transported and loaded correctly.
The cooling unit can also be loaded using M8 jack rings or placed on the switch cabinet. For this purpose, screw
the M8 jack rings into the cooling unit beforehand; Mounting M8 jack rings.
3.2 Storage
• Do not expose the cooling unit to temperatures above +70 °C during storage.
• Always store the cooling unit in the position of use.
The warranty will no longer apply if these instructions are not observed.
To Next Page
Loading...
Need help?
General