Pharma Test PT-Node - Section 5.1.2 Capturing PTB 111 EP Internal Printer Test Reports; Section 5.1.3 Capturing PTB 111 E Ticket Printer Test Reports; Table 7: PTB 111 E Ticket Printer Communication Details

Pharma Test Apparatebau AG
Operating Manual
B-24-00100_PT-NODE_v1.0e.docx Page 38 of 64
Section 5.1.2 Capturing PTB 111EP Internal Printer Test Reports
[section upcoming]
Section 5.1.3 Capturing PTB 111E Ticket Printer Test Reports
Parameter
Specification
Supported models
PTB 111E-300, PTB 111E-500, PTB 111E-800
Minimum firmware version
1.11
Connection
Serial 25pin D-Sub (male) plug labelled “RS232” on the
backside of the instrument, cable (part no. 34-00311)
Output parameters
9600 bit/s, 7 data bits, no parity, 1 stop bit, hardware
handshake
Printouts captured
Test report
Table 7: PTB 111E ticket printer communication details
5.1.3.1 Activating the Ticket Printer Printout
Set your instrument to print in the ticket printer format:
1. Turn on the instrument, the display shows all “0”
2. Press [CAL]+[6]+[2] to display the printer selection menu
3. Use [.] (point) to toggle between the settings until you see this setting:
Number
Hardness
P r
P r E P
4. Press [*] (star) to confirm the selection