Philips IntelliVue MX40 - Page 109

Technical Alarms (INOPs)
Troubleshooting 8-3
Alarm Text
Priority
Condition
What to do
Cannot Analyze ECG
Source - MX40 and
Information Center
(PIC iX only)
Hard Arrhythmia algorithm
cannot reliably analyze
the ECG data on any
monitored leads.
Assess the lead selections,
initiate relearn, and validate
analyzed rhythm. Check other
INOPs for possible source of
problem.
Cannot Analyze QT Soft The QT Arrhythmia
algorithm cannot reliably
analyze the QT data on
any monitored leads.
• Change electrodes and/or
electrode position.
• Change Primary lead.
Cannot Analyze ST Soft
The ST Arrhythmia
algorithm cannot reliably
analyze the ST data on
any monitored leads.
• Change electrodes and/or
electrode position.
• Change Primary lead.
!! Check Pairing
Source - MX40 and
Information Center
(IIC only)
Yellow
Technical
Alarm
• There is a problem
with device
assignment.
• When the MX40 is
wirelessly assigned
with an X2 patient
monitor (no label)
docked with a larger
networked MP series
monitor, the network
connection is lost.
• Check that the bedside
monitor or cableless
measurement device is
correctly assigned.
• Select the correct device to
be assigned.
Chk PulseT Limits
Source - MX40
Hard The HR/Pulse alarm limit
is set too high/low for the
pulse measurement
range
Set alarm limit within pulse
measurement range. Pulse
rate measurement range = >
25bpm - < 240bpm (Masimo
SET); > 30bpm - < 300bpm
(Philips FAST).
cl NBP Disconnect
Source - Cableless
Measurement Device
Hard
CL NBP Pod is not
connected with the
MX40.
• Resolve interference
condition.
• Reduce range between CL
NBP Pod and MX40.
cl NBP Batt Empty
Source - Cableless
Measurement Device
Hard CL NBP Pod empty
battery condition.
Monitoring is not
possible.
• Replace CL NBP Pod.
• Recharge depleted CL NBP
Pod.