Listening to the radio
07
51
En
Choosing stations
The tuner can receive both FM and AM
broadcasts, and lets you memorize your
favorite stations so you don’t have to
manually tune in every time you want to
listen.
SYSTEM SETUP
DVD SETUP
TOP MENU
DVD MENU
SUBTITLE
VOLUME
ANGLE ZOOM
ADVANCED
MONO
SYSTEM DISP
DVD DISP
ECHO
DSP
AUDIO
DVD/CD TAPE FM/AM LINE
SURROUND
KARAOKE
I
—
KEYCON
—
i
TIMER
CLOCK ADJ.
MUTE
RETURN
SOUND
MODE
ENTER
STANDBY/ON
/e
E/
1
¡
3
3
3
TUNE +
TUNE –
1 Press FM/AM (remote) or TUNER
(front panel) to switch to the tuner and
select the AM or FM band.
Press repeatedly to switch between AM and
FM. TUNER (front panel) switches between
FM, AM and station recall (this last option is
covered on page 53).
2 Tune to a frequency.
There are three tuning modes—manual,
auto, and high-speed:
Manual tuning: Press TUNE + or –
(TUNING + or – on the front panel)
repeatedly to change the displayed
frequency.
Auto tuning: Press and hold TUNE + or –
(TUNING + or – on the front panel) until
the frequency display starts to move,
then release. The tuner will stop on the
next station it finds. Repeat to search for
other stations.
High-speed tuning: Press and hold TUNE
+ or – (TUNING + or – on the front
panel) until the frequency display starts
to move rapidly. Keep the button held
down until you reach the frequency you
want. If necessary, fine tune the
frequency using the manual tuning
method.
Improving poor FM reception
If you’re listening to an FM station in stereo
but the reception is weak, you can improve
the sound quality by switching to mono.
1 Press MONO on the remote.
The MONO indicator lights when the tuner is
in mono reception mode.
Press again to switch back to auto-stereo
mode (the STEREO indicator lights when
receiving a stereo broadcast).
• To reduce noise while recording an AM
broadcast, see Improving AM tape
recordings on page 58.
To Next Page
Loading...
