Additional information15
86
En
Problem
The disc is ejected automatically
after loading.
Playback is not possible.
Picture playback stops and the
operation buttons cannot be
used.
Settings are canceled.
No picture/No color.
Screen is stretched or aspect does
not change.
When recorded on a VCR or
passed through an AV selector,
there is disturbance in the
playback picture.
Remedy
• Clean the disc.
• Align the disc properly in the disc guide.
• If the region number on a DVD-video disc does not match the
number on the player, the disc cannot be used (page 10).
• Allow time for any condensation inside the player to evapo-
rate. Avoid using the player near an air-conditioning unit.
• Disc is loaded upside down. Reload the disc with the label side
face up.
• Press 7, then start playback again (3).
• Switch the power off once, then on again using the front panel
STANDBY/ON button.
• When the power is cut due to power failure or by unplugging
the power cord (see Moving the unit, page 84), settings will be
canceled.
• Check that connections are correct and that plugs are inserted
fully.
• Check the instruction manual of the TV/monitor to make sure
the TV/monitor settings are incorrect.
• The TV Screen setting is incorrect. Set the TV Screen option to
match the TV/monitor you're using (page 74).
• Due to the player’s copy protection circuits, connection of this
device through a VCR or an AV selector may prevent recording or
cause picture problems. This is not a malfunction.
DVD/CD/Video CD player
Problem
Can’t operate the remote
control.
Feedback noise when mic is
switched on.
Remedy
• Replace the batteries (page 7).
• Operate within 23 feet ( 7 m), 30° of the remote sensor on the
front panel (page 8).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct
light.
• The mic is pointing toward the speakers. Keep the mic pointed
away from the speakers.
• The microphone level is set too high. Turn down the mic
control level.
To Next Page
Loading...
