Using the timer12
68
En
Setting the wake-up timer
Use the wake-up timer to set the system to
switch on at any time and start playing
whatever source you want.
SYSTEM SETUP
DVD SETUP
TOP MENU
DVD MENU
SUBTITLE
VOLUME
ANGLE ZOOM
ADVANCED
MONO
SYSTEM DISP
DVD DISP
ECHO
DSP
AUDIO
DVD/CD TAPE FM/AM LINE
SURROUND
KARAOKE
I
—
KEYCON —
i
TIMER
CLOCK ADJ.
MUTE
RETURN
SOUND
MODE
ENTER
STANDBY/ON
TUNE +
TUNE –
• The clock must be set to the correct
time for the wake-up timer to work
properly (see page 26).
• You can’t have the record timer and the
wake-up timer set at the same time.
1 Select the source you want played.
For example, press FM/AM (TUNER on the
front panel) to select the radio as your
source.
2 Prepare the source.
For example, tune in the radio station you
want to wake up to.
If you’ve selected a CD or tape, make sure
that it’s stopped.
3 Set the volume.
4 Press TIMER/CLOCK ADJ.
5 Use the
/
buttons to select WAKE-
UP.
On the front panel use 4/1 and ¡/
¢.
6 Press ENTER.
7 Use the
/
buttons to select EDIT.
On the front panel use 4/1 and ¡/
¢.
8 Press ENTER.
9 Set the switch-on time.
Use the
/
buttons (4/1 and ¡/¢
on the front panel) to set the hour, then press
ENTER. Set the minute in the same way,
pressing ENTER when you’re done.
10 Set the switch-off time.
Use the
/
buttons (4/1 and ¡/¢
on the front panel) to set the hour, then press
ENTER. Set the minute in the same way,
pressing ENTER when you’re done.
After pressing ENTER this last time, the
switch-on and switch-off times are confirmed
in the display.
11 Switch the system into standby mode.
WAKE-UP and the timer indicator (
) show
in the display to confirm that it’s set.
• The wake-up timer will not work if the
system is left on!
To Next Page
Loading...
