User’s Manual of GS-5220 LCD Series
287
• Delete
Check to delete the entry. The designated entry will be deleted during
the next save.
• MVR VID
Specify the Multicast VLAN ID.
Be Caution: MVR source ports are not recommended to be overlapped
with management VLAN ports.
• MVR Name
MVR Name is an optional attribute to indicate the name of the specific
MVR VLAN. Maximum length of the MVR VLAN Name string is 16. MVR
VLAN Name can only contain alphabets or numbers. When the optional
MVR VLAN name is given, it should contain at least one alphabet. MVR
VLAN name can be edited for the existing MVR VLAN entries or it can
be added to the new entries.
• IGMP Address
Define the IPv4 address as source address used in IP header for IGMP
control frames. The default IGMP address is not set (0.0.0.0).
When the IGMP address is not set, system uses IPv4 management
address of the IP interface associated with this VLAN.
When the IPv4 management address is not set, system uses the first
available IPv4 management address. Otherwise, system uses a
pre-defined value. By default, this value will be 192.0.2.1.
• Mode
Specify the MVR mode of operation. In Dynamic mode, MVR allows
dynamic MVR membership reports on source ports. In Compatible
mode, MVR membership reports are forbidden on source ports. The
default is Dynamic mode.
• Tagging
Specify whether the traversed IGMP/MLD control frames will be sent as
Untagged or Tagged with MVR VID. The default is Tagged.
• Priority
Specify how the traversed IGMP/MLD control frames will be sent in
prioritized manner. The default Priority is 0.
To Next Page
Loading...
Need help?
General