Planet IDL-2402 - Page 139

4.3.7.2 Interface Setup
This option allows you to setup the interface for IPoA/IPoE IWF. From the Bridge menu,
click on IPOA and then Interface Setup. The following page is displayed.
Click on the radio button to select a circuit, set values for the parameters, and then click
on Modify button.
IPoA Interface Setup
Label Descri
p
tion
Click on the drop-down list and select the line ports to be listed.
VPI Type in the VPI. Value range is 0 ~ 255.
VCI Type in the VCI. Value range is 21, 32 ~ 65535.
MaxMAC
Type in the maximum number of MAC addresses that can be learned by
the bridge port (for GBE interface: 1 ~ 4096, for DSL interface: 1 ~ 128).
CVID
Type in the VID value of C-Tag (the innermost VLAN tag as defined in
IEEE 802.1ad and having an EtherType value of 0x8100). The C-VID
indicates the access loop.
CVPRI
Click on the drop-down list and select the VLAN priority level of C-Tag
(Pri-0 ~ 7).
- 139 -