Code Explanation Comments
H186 No IP address defined for 3D
sensor.
H187 Problem during image data
transmission.
Exposure was interrupted.
Contact your service technician
for help.
H189 The screen was touched during
exposure.
Exposure was interrupted.
H190 Error in communication protocol
UID.
Retry or contact your service
technician for help.
H191 Error in communication protocol
state.
Retry or contact your service
technician for help.
H192 Command queue full. Retry or contact your service
technician for help.
H193 Invalid scan settings. Retry or contact your service
technician for help.
H194 The control panel (touch screen
or ProTouch desktop application)
is not connected to the ProMax
main software.
Operating in standalone mode.
H195 Request timed out while waiting
for ProMax to respond.
Retry or contact your service
technician for help.
H196 Version mismatch in
communication interfaces.
Update ProMax software.
H197 Eeprom reading failed. Retry or contact your service
technician for help.
H199 The 3D reconstruction PC does
not support the CALM algorithm.
Upgrade the 3D reconstruction
PC or deactivate the CALM
licence.
Contact your service technician
for help.
10 Help messages
User's manual Planmeca ProMax 101
To Next Page