9.2.4 Reset to Factory Defaults (2500)
To reset to factory defaults:
1. Select Program > 2500 Reset to Factory Defaults. The function will
restore the exposure values that have been preset at the factory (i.e.
overrule your own settings in menu Programs (2100)).
The preset exposure values are shown in sections “Adjusting exposure
values for current exposure”.
2. Select the green check mark button.
9.3 About tab
9.3.1 Component Information (4100)
To view component information:
Select About > 4100 Component Information > Show Component
Information to view the set-up or current software versions of the X-ray unit.
To view software build information:
Select About > 4100 Component Information > Show Detailed Build Info to
view details about the software build.
9 Settings
User's manual Planmeca ProMax 97
To Next Page
Loading...
Need help?
General
