Proxima, Libra firmware ver. 2.12.xx
rev. 2.12.01
Before programming, make sure that the proprietary phone is not blocked with a
PASSWORD. The phone should be hung up (idle user).
If you wish to activate the programming mode:
Press the PROGRAM button
The following message will be displayed: PROGRAMMING
Selection of any button is signalled with a double beep.
By pressing the COn button in the telephone or the Sn button in the console once,
you may view the currently ascribed extension user or trunk line numbers. By
pressing the button twice you may view the extension user or the trunk line number
ascribed to this button’s LED.
It is recommended for the settings of a given button to be the same as the settings
of the corresponding LED.
If you wish to change the settings of the trunk or extension line for a given
button or COn/Sn:
Enter the programming mode:
Push the programmed button – once if you want to change the button
settings or twice if you want to change the settings of the LED assigned
to this button.
Dial the correct number (e.g. *801*2*4# – a trunk line in the first unit,
second slot, 4th card port or e.g. ,117 – an extension number). The
<comma> mark is entered using the FLASH button.
It is recommended to enter the comma before the number in the button
settings. As a result, a direct, single-button call forwarding for a given user
will be possible. The comma should be omitted as far as the LED
settings are concerned.
When the proprietary phone buttons are being programmed, the LED is
flashing green.
When the console buttons or the proprietary phone/console LEDs are
being programmed, the button LEDs are flashing red.
To Next Page
Loading...