Proxima, Libra firmware ver. 2.12.xx
rev. 2.12.01
Press the STORE key to confirm the entered data. You will hear a double
beep and then, the programmed number will be displayed.
Programme the other buttons in the same way or press the PROGRAM
button again to exit the programming mode.
If the programmed user's number has been ascribed to another button
before, the previous setting will be cancelled. Thanks to this functionality,
you may programme the buttons without the need to delete the repeated
ports.
In the case of dialling wrong number, you’ll hear two long tones
signalising error. A previous setting will appear on the display.
If you want to delete the assignment settings without assigning the number:
Enter the programming mode:
Press a given button once if you want to remove the number assigned to
the button or twice if you want to remove the number assigned to the
LED.
Press STORE.
You will hear two beeps and the Removed message will be displayed.
Press the PROGRAM button again to exit the programming mode.
Programming the proprietary phone LEDs takes place after a given trunk button
has been pressed twice in the programming mode. The flashing LED will turn red
(the LED is green when the trunk button is being programmed after it has been
pressed once).
When programming the proprietary phone CO1 ÷ CO24 and the console S1 ÷ S60
buttons and LEDs, you dial the extension or the trunk line (CO) number consistent
with the current configuration. The server saves the assignment of buttons and
LEDs to proper ports.
If you send the current configuration including the new extension numeration (or
the access codes to trunk lines) to the server via the computer program, the settings
of the proprietary phones and DSS consoles will be changed automatically.
To Next Page
Loading...