Polycom CX5100 - Dns; Dns-A

Configuration Parameters
Polycom, Inc. 56
1
Change causes system to restart or reboot.
<dns/>
The <dns/> parameters include:
● DNS-A
● DNS-NAPTR
● DNS-SRV
You can enter a maximum of 12 record entries for DNS-A, DNS-NAPTR, and DNS-SRV. records.
DNS-A
Add up to 12 DNS-A record entries using the parameters in the following table. Specify the address, name,
and cache time interval for DNS-A record x, where x is from 1 to 12.
diags.pcap.remote.enabled 0 or 1 0
Enable or disable the remote packet capture server.
diags.pcap.remote.password alphanumeric <MAC Address>
Enter the remote packet capture password.
diags.pcap.remote.port Valid TCP Port 2002
Specify the TLS profile to use for each application.
DNA-A Parameters
Parameter Permitted values Default
dns.cache.A.x.address IP version 4 address Null
IP address.
dns.cache.A.x.name valid hostname Null
Hostname
dns.cache.A.x.ttl 300 to 536870912 (2^29), seconds 300
The TTL describes the time period the system uses the configured static cache record. If a dynamic network request
receives no response, this timer begins on first access of the static record and once the timer expires, the next
lookup for that record retries a dynamic network request before falling back on the static entry and its reset TTL timer
again.
Remote Packet Capture Parameters (continued)
Parameter Permitted Values Default