Configuration Parameters
Polycom, Inc. 71
<hostmovedetect/>
The next table lists configurable parameters.
<TLS/>
The next table lists configurable TLS parameters. For the list of configurable ciphers, refer to the table .
This parameter also includes:
● <profile/>
● <profileSelection/>.
If 0, the system software does not reset (recycle) the LAN port link in the application initiation stage. If 1, the LAN port
link resets in the application initiation stage.
1
Change causes system to restart or reboot.
Host Movement Detection Parameters
Parameter Permitted Values Default
sec.hostmovedetect.cdp.enabled
1
0 or 1 0
If set to 1, the system software unconditionally sends a CDP packet (to the authenticator switch port) to indicate a
host has been connected or disconnected to its secondary (PC) port.
sec.hostmovedetect.cdp.sleepTime
1
0 to 60000 1000
If sec.hostmovedetect.cdp.enabled is set to 1, there is an x microsecond time interval between two
consecutive link–up state change reports, which reduces the frequency of dispatching CDP packets.
1
Change causes system to restart or reboot.
TLS Parameters
Parameter Permitted
Values
Default
sec.TLS.browser.cipherList String NoCipher
The cipher list for browser. The format for the cipher list uses OpenSSL syntax found at:
http://www.openssl.org/docs/apps/ciphers.html.
sec.TLS.cipherList String “RSA:!EXP:!LOW:!NULL:!MD5:@STRENG
TH”
The global cipher list parameter. The format for the cipher list uses OpenSSL syntax found at:
http://www.openssl.org/docs/apps/ciphers.html.
sec.TLS.customCaCert.x String Null
The custom certificate for TLS Application Profile x (x= 1 to 6).
802.1X EAP over LAN (EAPOL) Logoff Parameters (continued)
Parameter Permitted Values Default