Configuration Parameters
Polycom, Inc. 59
<license/>
The parameters listed in the next table enable you to configure the feature licensing system.
<log/>
The event logging system supports the classes of events listed in the table Logging Levels. Two types of
logging are supported:
● level, change, and render
● <sched/>
httpd.cfg.port
1
1 to 65535 80
Port is 80 for HTTP servers. Care should be taken when choosing an alternate port.
httpd.cfg.secureTunnelEnabled
1
0 or 1 Generic=1
Lync=0
If 0, the web does not use a secure tunnel. If 1, the server connects through a secure tunnel.
httpd.cfg.secureTunnelPort
1
1 to 65535 443
The port to use for communications when the secure tunnel is used.
httpd.cfg.secureTunnelRequired
1
0 or 1 1
If 0, communications to the web server do not require a secure tunnel. If 1, communications do require a secure
tunnel.
1
Change causes system to restart or reboot.
Feature License Parameters
Parameter Permitted Values Default
license.polling.time
1
00:00 – 23:59 02:00
The time (using the 24-hour clock) to check if the license has expired.
1
Change causes system to restart or reboot.
Note: Removing the installed license
Once the license is installed on a system, it cannot be removed.
Caution: Changing the logging parameters
Logging parameter changes can impair system operation. Do not change any logging parameters
without prior consultation with Polycom Technical Support.
HTTPD (Web Server) Parameters (continued)
Parameter Permitted Values Default