Polycom CX5100 - Sched

Configuration Parameters
Polycom, Inc. 62
<sched/>
The system can be configured to schedule certain advanced logging tasks on a periodic basis. Polycom
recommends that you set the parameters listed in the next table in consultation with Polycom Technical
Support. Each scheduled log task is controlled by a unique parameter set starting with log.sched.x where x
identifies the task. A maximum of 10 schedule logs is allowed.
log.render.level 0 to 6 1
Specifies the lowest class of event rendered to the log files. This is the output filter from the internal memory-based
log system.
The log.render.level maps to syslog severity as follows:
0 SeverityDebug (7)
1 SeverityDebug (7)
2 SeverityInformational (6)
3 SeverityInformational (6)
4 SeverityError (3)
5 SeverityCritical (2)
6 SeverityEmergency (0)
log.render.realtime 0 or 1 1
Set to 1. Polycom recommends that you do not change this value.
log.render.stdout 0 or 1 0
Set to 0. Polycom recommends that you do not change this value.
log.render.type 0 to 2 2
Refer to the table Event Timestamp Formats for timestamp type.
Logging Schedule Parameters
Parameter Permitted Values Default Value
log.sched.x.level 0 to 5 3
Event class to assign to the log events generated by this command. This needs to be the same or higher than
log.level.change.slog for these events to display in the log.
log.sched.x.name alphanumeric string
Name of an internal system command to be periodically executed. To be supplied by Polycom.
log.sched.x.period positive integer 15
Seconds between each command execution. 0=run once
log.sched.x.startDay 0 to 7 7
When startMode is abs, specifies the day of the week to start command execution. 1=Sun, 2=Mon, ..., 7=Sat
Logging Level, Change, and Render Parameters (continued)
Parameter Permitted Values Default