Configuration Parameters
Polycom, Inc. 67
<sec/>
The parameters listed in the next table configure security features of the system.
This parameter also includes:
● <encryption/>
● <pwd/><length/>
● <srtp/>
● <dot1x><eapollogoff/>
● <hostmovedetect/>
● <TLS/>
qos.ip.rtp.video.dscp
1
0 to 63 or EF or any of AF11,AF12, AF13,AF21,
AF22,AF23, AF31,AF32, AF33,AF41,
AF42,AF43
Null
Allows the DSCP of packets to be specified. If the value is non-null, this parameter overrides the other
qos.ip.rtp.video.*parameters. The default value is Null, so the other qos.ip.rtp.video.* parameters
are used.
qos.ip.rtp.video.max_reliability
1
qos.ip.rtp.video.max_throughput
1
qos.ip.rtp.video.min_cost
1
qos.ip.rtp.video.min_delay
1
qos.ip.rtp.video.precedence
1
0 or 1
0 or 1
0 or 1
0 or 1
0 -7
0
1
0
1
5
Set the bits in the IP ToS field of the IP header used for RTP video. Specify whether or not to set the max reliability
bit, the max throughput bit, the min cost bit, the min delay bit, and the precedence bit.
If 0, the bit in the IP ToS field of the IP header is not set. If 1, the bit is set.
1
Change causes system to restart or reboot.
General Security Parameters
Parameter Permitted Values Default
sec.tagSerialNo
1
0 or 1 0
If 0, the system does not advertise its serial number (MAC address) through protocol signaling. If 1, the system may
advertise its serial number through protocol signaling.
1
Change causes system to restart or reboot.
Quality of Service (Type-of-Service) Parameters (continued)
Parameter Permitted Values Default