(Adapted by Atlantic Broadband)
video enabled who joined the conference. If you use the Join soft key to set up the conference, you see the
video of the person who was held just prior to joining the conference.
Note: Viewing all video participants requires the use of a Polycom Video Conference Bridge. For more
information, contact your Polycom reseller.
When your system administrator enables the conference management feature on your phone, you can
select whose video to see.
» During a conference call, select a contact and tap Select Video.
The Select Video soft key does not display when you're currently exchanging video with the selected
party, or when the party does not have video capability.
The person who previously displayed video is replaced with the person you selected.
R
ELATED INFORMATION:
Conference Calls
Manage Conference Call Participants
Managing Video Calls without a VVX Camera
When you do not have a VVX Camera attached to your VVX 500 or 600 phone, you can receive
video, but
you cannot send video. Video always displays when the person you are talking with can send
video, and
your phone is enabled to receive video.
If you place a video call on hold, the person's video stream stops and is replaced by a paused grayscale
image taken just before you held the call, as displayed next. The person's video stream returns when you
resume the call.
Figure 8: Held video call
View Video in Full Screen during Calls
During a video call, you have the option of viewing video on the full screen instead of in the smaller Active
Call screen.
» Do one of the following:
Tap
.
Tap the video area to view video on the full screen.
To Next Page
Loading...
Need help?
General
