EasyManua.ls Logo

Polycom VVX 201 - Use Personal Photos as Screen Savers

Polycom VVX 201
120 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Polycom, Inc.
(Adapted by Atlantic Broadband)
85
Customizing Your Phone
Use Personal Photos as Screen Savers
On VVX 500 and 600 phones, you can enable your phone to display your personal
photos as a screen
saver. To set up a screen saver of your pictures, you need to set up certain screen saver
settings, place
your pictures on a USB flash drive, and attach the USB flash drive to the phone.
The pictures you use must have the following file type and size properties:
File type: BMP, JPEG, or PNG
Maximum size: 9999 x 9999 pixels
The phone can only display the photos as your screen saver when the USB flash drive is attached to the
phone.
You can set up your phone to use a single picture to display or have all pictures display in slide-show style.
This is an alternative to setting up a screen saver, and it automatically starts each time your phone is idle a
certain amount of time.
TASK
1
Place one or more pictures on a USB flash drive, either in the root directory or in a folder.
2
Attach the USB flash drive to your phone.
The USB icon is displayed on the status bar.
3
Navigate to Settings > Basic > Preferences > Picture Frame.
4
From the Picture Frame screen, select Folder, and enter the name of the folder you placed your
images in on the USB flash drive.
If you did not place the pictures in a folder, but placed them in the root directory instead, do not enter
a folder name.
5
Select Time Per Image, and enter the number of seconds you want each picture to display.
You can enter a minimum of 3 seconds and a maximum of 300 seconds. The default is 5 seconds.
6
Select Save.
If the message “No pictures found” displays after you select Save, there are no pictures in the folder
you specified or in the root directory. Go back and make sure the information you entered is correct.
7
Navigate to Settings > Basic > Preferences > Screen Saver.
8
From the Screen Saver screen, select Screen Saver, and select Enabled.
9
Select Wait Time, and enter the number of minutes the phone should wait, after no activity, before
displaying the screen saver.
You can enter any time between one minute and of 9999 minutes. The default is 15 minutes.
10
Select Save.
Your phone displays the screen saver after the number of minutes you specified in the Wait Time field.
Note: If your phone does not detect the USB flash drive when you attach it to your phone, the USB
port on your phone may be disabled. Contact your system administrator.

Table of Contents

Other manuals for Polycom VVX 201

Related product manuals