Power Electronics SD700 Series User Manual

POWER ELECTRONICS
SD700
DESCRIPTION OF PROGRAMMING PARAMETERS
39
4.8.2. Subgroup 8.2 – S8.2: Analogue Outputs
Parameter /
Default Value
Name /
Description
Range
Function
Set on
RUN
1 ANLG OUT1=01
G8.2.1 / Mode
selection for
Analogue Output
1
00 – 27
Analogue output is programmable according to the following table:
OPT
DESCR.
FUNCTION
UNITS
00
NONE
It is not used.
-
01
SPEED
MOTOR
Signal proportional to
the motor speed.
% Motor speed
02
CURRENT
MOTOR
Signal proportional to
the motor current.
% Motor rated
current
03
VOLTAGE
MOTOR
Signal proportional to
the motor voltage.
% Motor rated
voltage
04
POWER
MOTOR
Signal proportional to
the motor power.
% Motor power
05
TORQUE
MOTOR
Signal proportional to
the motor torque.
% Motor torque
06
PF MOTOR
Signal proportional to
the motor power factor.
% Motor rated
Cosine Phi
07
TEMP
MOTOR
Signal proportional to
the motor temperature.
% Motor
temperature
08
FREQUENCY
IN
Signal proportional to
the input frequency.
% Input
frequency
(50Hz=100%)
09
INPUT
VOLTAGE
Signal proportional to
the input voltage.
% Equipment
rated voltage
10
DC BUS
Signal proportional to
the DC Bus voltage.
% Motor voltage
x 1.414
11
DRIVE TEMP
Signal proportional to
the drive temperature.
% Drive
temperature
12
SPEED REF
Signal proportional to
the speed reference.
% Motor speed
13
Reserved
Reserved for future
use.
14
PID
REFERENCE
Signal proportional to
the reference in PID
mode.
%
15
PID
FEEDBACK
Signal proportional to
the feedback in PID
mode.
%
16
PID ERROR
Signal proportional to
the error (difference
between reference and
feedback) in PID mode.
%
17
ANLG INPUT
1
Analogue input 1 signal
is transferred to
analogue output.
%
18
ANLG INPUT
2
Analogue input 2 signal
is transferred to
analogue output.
%
19
ANLG
INPUT1+2
The average of the
analog inputs 1 and 2.
%
20
CURRENT
FLOW
Analogue signal
proportional to the read
flow through analogue
input or pulse input.
%
21
MAX SCALE
It forces the output to
maximum value.
100% bottom
scale
22
ABSOLUT
SPEED
Signal proportional to
the motor speed without
sign (absolute value).
% Motor speed
23
ABSOLUT
TORQUE
Signal proportional to
the motor torque
without sign (absolute
value).
% Motor torque
24
ENCODER
SPD
Signal proportional to
the real speed of the
encoder
% rpm (motor
nameplate)
NO
NO
2 FORMT 1=4-20 mA
G8.2.2 / Format
selection for
Analogue Output
1
0-10V
±10V
0-20mA
4-20mA
Analogue output 1 is programmable in one of four possible formats according to
the system requirements.
NO

Power Electronics SD700 Series Specifications

General

Brand	Power Electronics
Model	SD700 Series
Category	Inverter
Language	English