SECTION 06B: X3 SERIES ELECTRICAL
76
PA1621 Maintenance Manual All Series | Jul 2017
4. Replace the screen lens by first inserting
one side in the seat, then push the other
side in and snap it in place by running it in
from one corner to the next.
FIGURE 65: LED DIRECT LIGHTING AND LENS
12.4.3 Removal and Replacement of Reading
Lamp Bulb
1. Engage the tool (#830164) over the lamp
and turn one quarter turn counterclockwise.
Then, remove the tool slowly.
2. Pull the bulb socket off the reading lamp
unit.
3. Push and turn bulb counterclockwise, then
pull it out of the socket.
4. Install new bulb in the socket, then push and
turn clockwise to lock bulb in position.
5. Push the bulb socket in the reading lamp
unit.
6. Position the reading lamp with the tool
(#830164), turn one quarter turn clockwise.
12.5 ENGINE COMPARTMENT LIGHTING
Three 24-volts LED modules illuminate the
engine compartment when the following
conditions are met:
1. The engine compartment rear door or
curbside door is open.
2. Ignition switch in ON or ACC position.
The light module is sealed thus not serviceable.
FIGURE 66: ENGINE COMPARTMENT LIGHT
To Next Page
Loading...
Need help?
General
