Primes PROFINET - Distinction by the Interface, the Possibility to Measure Pulsed Lasers and a Reduced Thermalization Time; Distinction by the Interface and the Measurable Wavelength Range; Devices with UL Marking

PowerMeasuringModule PMM
35,0(6
13
Revision 13 EN - 02/2023
4.1.2 Distinction by the interface, the possibility to measure pulsed lasers and a reduced
thermalization time
Interface Advanced absorber
With the AP3s marking, pulsed lasers can also be measured and the device is designed
for a reduced thermalization time.
PROFINET
®
PROFIBUS
®
DeviceNet™
EtherCAT
®
Further interfaces on
request
Tab. 4.2: Distinction through the interface, the possibility to measure pulsed lasers and a reduced thermalization time
using the PMM PROFINET
®
as an example
4.1.3 Distinction by the interface and the measurable wavelength range
Interface Advanced Absorber
With the “BG” mark, the device is suitable for measuring blue/green wavelengths. With-
out “BG” mark, the device is suitable for measuring NIR wavelengths.
The measurable wavelengths are marked on the lower edge of the identification plate.
PROFINET
®
PROFIBUS
®
Parallel
DeviceNet™
EtherNet/IP™
EtherCAT
®
Tab. 4.3: Distinction by the interface and the measurable wavelength range
using the PMM PROFINET
®
as an example
4.1.4 Devices with UL marking
Interface Standard absorber
The type of absorber is indicated on the
identification plate.
Advanced absorber
The type of absorber is indicated on the
identification plate.
PROFINET
®
LWL (Fiber
optics)
Tab. 4.4: Distinction by the interface and the absorber type on the PROFINET
®
LWL (Fiber optics)
with UL marking.