PowerMeasuringModule PMM
35,0(
20
Revision 13 EN - 02/2023
6.3 Removal from the laser system
1. Switch off the laser beam.
2. Ensure that moving parts, e.g. robot arms, etc. are at a standstill and that they cannot be set in motion
unintentionally.
3. Close the shutter.
4. Switch off the power supply.
5. Unscrew the mounting screws.
6. Disconnect the electrical connections.
7. Remove the device from the laser system.
8. Insert the transport lock into the device (see transport lock supplement).
9. To avoid contamination, pack the device in a suitable plastic film or bag.
To Next Page
Loading...
