SECTION 3
3-4 PROCLEIX
®
TIGRIS System Operator’s Manual
Part # 902649EN Rev. A Volume I: Operating the Instrument
If specimens are being deleted, a confirmation dialog box opens. Click OK to
confirm.
The Worklist Details
grid in the Edit Carousel Worklist window updates to display
the new specimen count.
4. Use the Edit Tests... button to change the number of replicates for an individual specimen
in the worklist:
a) On the Worklist Details
grid, select the specimen to be edited.
b) Click Edit Tests....
An Edit Tests
window opens
c) Enter the new number of replicates.
d) Click OK.
5. Click OK to confirm.
6. When all of the changes in the Edit Carousel Worklist
window are completed, click Done.
The Worklist Details
grid on the Worklist Manager updates to display the new
information for the worklist and its samples.
Printing a Worklist
Use the Worklist Manager to print a worklist of tests. Use the printed worklist as a guide for
correct placement of calibrators, PROCLEIX
®
TIGRIS Controls, and specimens.
1. In the Stored Worklists
grid, select the worklist to be printed.
2. At the bottom of the Worklist Detail
box, click Print Worklist….
A print dialog box opens.
3. Make any necessary changes to the printer set-up.
4. Click OK.
Deleting a Worklist
Use the Worklist Manager to delete a stored worklist.
1. In the Stored Worklists
grid, select the worklist to be deleted.
2. Click Delete Worklist.
A confirmation dialog box opens.
3. Click OK.
The system deletes the worklist from the PROCLEIX
®
TIGRIS System database and
removes it from the Stored Worklists
grid.
Note: The Edit Tests... button is disabled when a calibrator or PROCLEIX
®
TIGRIS Control is selected.
Note: A worklist must be de-queued before it can be deleted.
Note: The ID number of the deleted worklist is not used again.
To Next Page
Loading...