FastTrak TX4650, TX2650 User Manual
126
What system BIOS setup settings do I use for the drives on the FastTrak?
None. The drives on the FastTrak TX Series are supported by the FastTrak
BIOS and/or OS drivers, not by your system BIOS.
How do I partition and format my FastTrak logical drive?
You can partition and format your logical drive using any file system you
want. See “Appendix A: Partition and Format” on page 137.
Critical logical drive status error reported during boot
If a critical status error message appears on the FastTrak BIOS startup
screen for a RAID 1, 5 or 10 logical drive, a physical drive has failed or is not
responding. See “Responding to a Critical or Offline Logical Drive” on
page 101.
Physical drives cannot be formed into a logical drive
Physical drives must support SATA or SAS and be free of media defects in
order to be added to a logical drive. Promise recommends using new
identical physical drives for each logical drive. Also, re-check the data and
power cabling and connections.
System CMOS displays C: or D: drive failure during Startup
Do not reference C: or D: in the Motherboard Standard CMOS for drives
attached to the FastTrak TX Series RAID Controller. Only enter drive
information in the Motherboard CMOS for drives attached to the onboard
IDE controller.
To Next Page
Loading...
Need help?
General
