Chapter 5: Configuration
Decoded (Internal) Scanners
146 WORKABOUT PRO G2 Hand-Held With Windows Embedded CE 5.0 User Manual
UPC-A, Preamble
When you double-tap on this parameter, a dialog box is displayed where you can
choose one of three options for lead-in characters for UPC-A symbols transmitted to
the host device:
System Char – system character transmitted with the data,
Country Code and System Char – both the country code (“0” for USA) and system
character are transmitted with the data, or
None – no preamble is transmitted. The lead-in characters are considered part of the
symbol.
Prefix/Suffix
See “Prefix/Suffix” beginning on page 144.
5.11.2.10 UPC E
Enabled UPC-E
Set this parameter to ON to allow “UPC E” bar code scans.
Enabled UPC-E1
Set this parameter to ON to allow “UPC-E1” (zero suppressed) bar code scans.
UPC-E And UPC-E1 Check Digit
If you enable one or both of these parameters, a check digit is included with the
decoded bar code data.
UPC-E And UPC-E1 Preamble
When you double-tap on one of these parameters, a dialog box is displayed where
you can choose one of three options for lead-in characters for UPC-E and UPC-E1
symbols transmitted to the host device:
System Char – system character transmitted with the data,
Country code and System Char – both the country code (“0” for USA) and system
character are transmitted with the data, or
None – no preamble is transmitted. The lead-in characters are considered part of
the symbol.
To Next Page
Loading...
