Psion Teklogix Workabout PRO G2 - UPC;EAN Shared Settings; Code 93

Chapter 5: Configuration
Decoded (HHP)
160 WORKABOUT PRO G2 Hand-Held With Windows Embedded CE 5.0 User Manual
Transmit Number System
If this parameter is enabled, the number system digit is transmitted with the decoded
bar code data.
Addendum Add-on 2 And Addendum Add-on 5
An addendum is a separate bar code, supplementary to the main bar code.
Enabling these parameters defines the length of the addendum bar code to either
2 or 5 characters.
Addendum Required
When this parameter is set to on, the scanner does not accept the main bar code
without an addendum.
Addendum Separator
“Addendum Separator” is a space that is added between the UPC E bar code and the
Add-on code/Addenda. When this parameter is set to on
, the scanner does not
accept the main bar code without an addendum.
Prefix/Suffix
Refer to “Prefix/Suffix” beginning on page 144.
5.11.3.10 UPC/EAN Shared Settings
Extended Coupon Code
This parameter specifies whether or not the imager will read only UPC-A/EAN-13
bar codes that have addenda.
Note: The 2 or 5 digit addenda must be turned on/off, depending on the desired
behavior.
5.11.3.11 Code 93
Enabled
Set this parameter to on to enable “Code 93”.