Chapter 2: Basic Checkout
Performing A Cold Reset – Accessing The BooSt Menu
32 WORKABOUT PRO G2 Hand-Held With Windows Embedded CE 5.0 User Manual
Note: You do not need to reset your WORKABOUT PRO G2 after configuring
the radio.
2.8.2 Performing A Cold Reset – Accessing The BooSt Menu
• Press and hold down the centre [SCAN] key and then press the [BLUE] and
[ENTER] keys simultaneously for a minimum of six seconds.
After a cold reset, the BooSt menu appears, listing possible BooSt commands.
• To load the Windows Embedded CE 5.0 operating system, type 1.
Note: Authorized personnel can perform a ‘
clean start’. A clean start resets
not only the registry settings to factory defaults, but also erases any
files or applications stored or installed on the built-in flash file sys-
tem. After a clean start, anything that is not part of the OS image is
erased.
Only data stored on a SD/MMC card or externally to the
device on a USB memory stick or on a PC is preserved during a
clean start.
To Next Page
Loading...
