Page 149
P123 High Level in
This parameter sets the distance that is full (span) when using the optional
current input, (Aux. input) instead of an ultrasonic transducer.
P124 Low mA Trim
This parameter allows you to “calibrate” the Ultra 5 to the Low mA Input
from the device being used. If the expected low value, from the device
connected to the mA Input, is not displayed, then you can trim it using this
parameter.
P125 High mA Trim
This parameter allows you to “calibrate” the Ultra 5 to the High mA Input
from the device being used. If the expected high value, from the device
connected to the mA Input, is not displayed, then you can trim it using this
parameter.
To Next Page
Loading...
Need help?
General
