EasyManuals Logo

Pulsar ULTRA 5 User Manual

Pulsar ULTRA 5
258 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #232 background imageLoading...
Page #232 background image
Page 224
Service Alarm
This feature is only available in units with firmware version 7.4.3 or
greater.
P194 Date
This parameter allows you to set the date when the service will be due i.e.
19/04/15. This will change automatically after a reset (P199) to the new
date, as set in Interval’ (P195).
Default = 01/01/14 (DD/MM/YY).
P195 Interval
This parameter allows a repeat interval (in days) to be set to indiciate the
time between each service. When a service alarm is triggered and then reset
using P199the new date in P194will increment by the amount of days
entered here. For example, if 365 has been entered then after a reset is done,
the new alarm will automatically be set to activate in 365 days’ time. 7 days
prior to an alarm activating a message will appear on the unit notifying the
user how long they have remaining until their service is due, which will be
displayed as follows:
Site service due in 7 days please call your provider Tel no. 01684 891371
At 12 noon, each day on the unit this interval will reduce until the service is
due. The service alarm relay that is programmed (details of how to do this
are shown in Relays > Alarms’) changes state and the LED becomes solid
red. The message displayed on the unit now changes to read as follows:
Site service now due please call your provider Tel no. 01684 891371
P196 STD Leading zeroes
This parameter is used to enter the number of 0’s that appear the beginning
of the phone number that is shown on the screen when the service alarm
messages are displayed. For example, enter ‘00’ for international number,
and enter ‘0’ for a local STD number.
P197 Phone STD code
This parameter is used to enter the STD’ or ‘Area code’ of the phone
number that is shown on the screen when the service alarm messages are
displayed. If ‘00’ or ‘0’ has been entered P196then you do not need to
enter a zero into this parameter for an STD code or mobile number. Instead
enter the first four digits you wish to be displayed e.g. enter 1684 for a
landline, or enter 7999 for a mobile.
P197 Phone number
This parameter is used to enter the digits of the remaining telephone or
mobile number e.g. enter 891371 for a landline, or 123456 for a mobile.

Table of Contents

Other manuals for Pulsar ULTRA 5

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pulsar ULTRA 5 and is the answer not in the manual?

Pulsar ULTRA 5 Specifications

General IconGeneral
BrandPulsar
ModelULTRA 5
CategoryController
LanguageEnglish

Related product manuals