Page 100
Chapter 7 Flow
When Ultra Wizard = 3 Flow
Ultra 5 configured as a Flow 5
This quick set-up guide shows you how to get up and running within a few
minutes of installing your Flow 5.
Enter Program Mode
First you need to go from run mode into program mode. Assuming the
passcode is the default 1997, then you should enter this.
Choose Quick Setup
Now you need to go into the quick setup. You will see on the display the
words ‘Ultra Wizard’, press the ‘right hand’ arrow key and this will take you
to the ‘Quick Setup’ menu option. Try pressing either of the two arrow keys
to see some more menu options, but return to Quick Setup, and press
This takes you to the “Quick Setup Menu”.
This takes you to the common applications
menu, and a number of options will appear on
the display.
Note
If you have already setup a common application, then there will be a number
shown other than 0, and you will see messages showing what the current
setup is. If you want to reset this and start again, press 0 (which will reset all
the quick setup parameters), otherwise pressing E NTER will allow you to
edit the parameters that have been set.
To Next Page
Loading...
