Page 225
P199 Service alarm reset
After the service is carried out, use this parameter to reset the service alarm.
To enable a reset, enter a value of ‘1’ and press ‘ENTER’ and the alarm is
now reset. If an ‘Interval (P195)’ is set, then ‘Date (P194)’ will
automatically increment by this amount of days.
Important Information
A service alarm relay must be programmed in the unit for the service alarm
to work correctly.
Device Comm.
RS232 Set Up
P061 Comms Baud
This parameter is used to set the speed (Baud Rate) of the RS232
communications and can be changed to suit the connecting device.
Default = 19200
RS 485 Set Up
Please refer to the relevant communications manual for availability of
parameters and details of options.
Remote Alarm
When a Modem is connected to, via the RS232 port, (Consult Pulsar or your
local distributor for further details), the following parameters are used to set
up the Ultra 5 so that when the level reaches a specific alarm point, as
determined by the setting of the relay(s) the unit will dial and connect to a
remote telephone number to provide details of the event.
P144 Call Type
This parameter determines what type of connection is made via the modem.
Remote alarm function is disabled
This option initiates a connection to a
remote modem/computer which will then
allow remote communication with the unit.
Please consult Pulsar or your local
distributor for further details.
To Next Page
Loading...
Need help?
General
