Page 29
3) Auxiliary Display, scrolling twelve-digit display.
Run Mode, displays measurement units (P104), status messages on
signal and transducer, detail of Hot Key function selected. It can be also
programmed to provide notification messages on alarms and pumps etc.
for full details please refer to Display Parameters in the relevant
parameter listing.
Program Mode, displays Menu and Sub Menu headings, parameter
details and options.
4) Communicator status enunciator displays the current status of, Remote
Communicator (rack and panel versions only) or remote PC connection.
5) Bargraph, display, gives visual indication of measurement in % of span.
6) Level indicators
Run Mode, indicates in which direction the level is moving.
Program Mode, indicates at which level of the menu system you are at.
The display on the wall, fascia, rack and panel mount unit contain the same
information, the difference being the aspect ratio of each display.
There are two main operating modes for your Ultra 5, Run Mode and
Program Mode. There is also a Test Mode, used for checking the set-up.
All modes are now described.
Run Mode
This mode is used once the Ultra 5 has been set up in program mode. It is
also the default mode that the unit reverts to when it resumes operation after
a power failure.
When Ultra 5 is switched on for the first time, it will display, in metres, the
distance from the transducer face to the target. All relays by default are
switched off.
After programming is complete, any relays that are set will operate when the
level reaches the relevant setpoint, and the LED’s will change colour (unless
specifically switched off).
To Next Page
Loading...
