PCX SMS AND PCX 256 SYSTEM MANUAL
Page: 22 RINS871-3
CHAPTER 5: TECHNICAL SPECIFICATION
This chapter outlines the essential specifications for the PCX range.
Pyronix Ltd. reserves the right to change these specifications at any time, without notice, in the interests of
product improvement.
Please ensure that this information is used in designing the system, so that it can be installed and
programmed as intended, and will continue to function reliably. In particular, system outputs and power
supplies must be used within their rated specifications.
5.1 Introduction
The PCX range has been designed to offer a choice of options to suit most European security applications.
All systems can be controlled using PIN code and/or proximity cards.
All products are compatible with the Digi Modem for remote signalling, downloading and/or SMS text
messaging.
Training courses are available on application to the sales office.
EN-50131
The PCX range is suitable for installation in systems specified below:
Product Security Grade Environmental Class
PCX 26/SMS 1 and 2 1 and 2
PCX 256 1 to 3 1 and 2
Power supplies conform to EN-501346
BS-4737
The PCX range has the facilities required to be able to control a system installed to BS-4737 requirements.
Compliance Statement
The PCX range complies with the requirements of the European EMC Directive (89/336/EC) and
the Low Voltage Directive (72/23/EC and 93/68/EC).
It is essential that the recommendations in this manual are followed, and that equipment and wiring be
installed so as to avoid the effects of potential sources of interference.
The PCX range fully complies with the requirements of DD243:2002. This has been verified using the BSIA
“Manufacturer’s Check List for Compliance with the Requirements of DD243:2002”.
All appropriate facilities and options are available for systems using sequential confirmation signalling
except: Zeroing of ‘Confirm Timer’ if first input to alarm retriggers.
When all parts are working normally, this equipment in combination with the PSTN and suitable
ARC equipment will meet the requirements of ATS2.
PCX 26/SMS/26: This product complies with TS50131-3:2003 and is suitable for use in EN50131-
6:1998 systems at security grade 2, environmental class 2.
UK = Suitable for use with systems installed to PD6662:2004 (AMD)
EXPORT = Suitable for use with systems installed to EN50131-1
PCX 256: This product complies with TS50131-3:2003 and is suitable for use in EN50131-6:1998
systems at security grade 3, environmental class 2.
UK = Suitable for use with systems installed to PD6662:2004 (AMD)
EXPORT = Suitable for use with systems installed to EN50131-1
To Next Page
Loading...
Need help?
General
