Pyronix 256 - Text Programming; Arm; Disarm System

PCX SMS AND PCX 256 SYSTEM MANUAL
Page: 42 RINS871-3
12.4 Text Programming
Text may be programmed for input names, for the ‘sign-on’ message, and to identify the arm level being
armed / disarmed. Each keypad key is allocated characters as shown below:
,/+.1 abc2 def3 ghi4
jkl5 mno6 pqrs7 tuv8
wxyz9 space0
Press the relevant key the appropriate number of times – e.g. for the letter ‘k’ press the  key twice, or for
the letter ‘s’ press the  key four times.
In addition, the k mnpkeys are used as follows:
k = make the character into a capital
m= move cursor left
n= clears cursor / adds a space
p= moves cursor right
12.5 Arm / Disarm System
If you do not have access to a user code, arming and disarming the system can be done using the
engineer’s code.
Visual Keypad Programming Procedure
ARM / DISARM SYSTEM
¾ Enter the Engineer Code (default 9999).
¾ “ARM / DISARM SYSTEM?” will be displayed
¾ Press the Okey
Select the partition(s) / level arm you would like to
arm. Press the Okey. The system then will begin
to arm.
To disarm the partitions, enter the engineer code,
and wait a couple of seconds. ‘ARM/DISARM
SYSTEM’ will be displayed, press the Okey.
To disarm the partitions, press the Pkey.