SECTION 3
OPERATING PRINTER
64
System Status
This screen opens when you access the Toolbox. It provides information about the Printer.
Status Indicator (upper left corner) shows Printer activity as
ONLINE, ERROR, MAINT (maintenance), PRINTING or PAUSED.
When “PRINTING”, the gray box (below Status Indicator) shows the name of
the job being processed/printed. Example: Printhead Test
Page shows page count for current or most-recent job.
Job shows number of jobs printed. Click on “X” to reset counter.
Session shows total number of pages printed for all jobs. Click on “X” to reset
counter.
Mid-Job counts down pages until the next automatic Printhead maintenance will
be performed by the Service Station. Value can be adjusted on the User Interface
screen, Mid-Job Servicing. In this example, service is performed every 200
pages.
Idle-Timer shows how often automatic maintenance will run when Printer is
“Idle” (not being used). In this example “2/360”, 2 = elapsed idle minutes.
360 = preset amount of minutes Printer must be idle before automatic
maintenance is performed.
Value (minutes) can be set in the User Interface screen, Idle Timeout (min).
Wiper Transfer shows how often a Wiper Transfer (removal of excess ink from
Service Station’s Wiper Roller) will be performed, in relation to when a
Printhead maintenance is performed.
Value can be set in User Interface screen, Wipe Transfer Frequency.
Ink Levels displays estimated percentage of ink remaining in each Ink Tank.
Date and Time shows currently set date and time. Values can be configured and
set in Service Menus screen, System Settings, Date and Time.
Relative Humidity (RH) displays current RH, detected within printer.
NOTE: Additional Printer Messages may appear under “RH” area.
To Next Page
Loading...
