Configuring Administrator Access
Quantum Spark 1500, 1600 and 1800 Appliance Series R80.20.40 Locally Managed Administration Guide | 112
An administrator can use the configured IP addresses to access the appliance through the allowed
interface sources.
To allow administrator access from both specified and any IP addresses:
Select this option when it is necessary to allow administrator access from the Internet (you must define the
specified IP addresses). Access from other sources is allowed from any IP address.
1. Select the Internet source checkbox.
2. Select the Specified IP addresses from the internet and any IP address from other sources option.
3. Click New.
The IP Address Configuration page shows.
4. Select Type:
n
IPv4 address
n
IPv4 network
n
IPv6 address
n
IPv6 network
5. Enter the IP address or click Get IP from My Computer.
6. Click Apply.
The IP address is added to the table.
7. Change the WEB Port (HTTPS) and/or SSH port if necessary.
8. Click Apply.
An administrator can use the configured IP addresses to access the appliance through the allowed
interface sources.
To delete administrator access from a specific IP address:
1. Select the IP Address you want to delete from the IP Address table.
2. Click Delete.
Important Notes:
n
Configuring different access permissions for LAN and Internet is not supported when your Internet
Connection is configured in bridge mode (the option Allow administration access from does not
show Internet or LAN).
n
An automatic implied rule is defined to allow the access specified here. There is no need to add an
explicit rule in the Access Policy page to allow this access.
n
When you block the IP address or the interface group through which you are currently connected, you
are not disconnected immediately. The access policy is applied immediately, but your current session
remains active until you log out.
To Next Page
Loading...
Need help?
General
