Configuring a Hotspot
Quantum Spark 1500, 1600 and 1800 Appliance Series R80.20.40 Locally Managed Administration Guide | 89
Configuring a Hotspot
In the Device > Hotspot page, if a network interface was defined for hotspot, you can configure:
n
Guest access - A session is created for an IP address when a user accepts terms or authenticates in
the Hotspot portal. The session expires after the configured timeout (240 minutes by default).
n
Hotspot portal - Customize the portal's appearance.
n
Hotspot exceptions - Define specified IP addresses, IP ranges or networks to exclude from the
Hotspot.
If no network interface was defined for the Hotspot, click Configure in Local Network.
In the Access section of the page, you can configure if authentication is required and allow access to all
users or to a specified user group (Active Directory, RADIUS or local).
Hotspot is automatically activated in the system.
To disable Hotspot:
1. Go to Device > Advanced Settings.
2. Search for Hotspot and double-click the entry.
3. Select Disabled.
4. Click Apply.
To configure Hotspot for an interface:
1. Click Configure in Local Network.
The Local Network window opens.
2. Select interface and click Edit.
The Edit <interface> window opens.
3. Select Use Hotspot.
4. Click Apply.
Any user that browses from configured interfaces is redirected to the Check Point Hotspot portal.
To Next Page
Loading...
Need help?
General
