SNMP
Quantum Spark 1500, 1600 and 1800 Appliance Series R80.20.40 Locally Managed Administration Guide | 286
SNMP
SNMP is a protocol for sending data and is used for monitoring. SNMP traps are alert messages sent as a
result of monitoring conditions. SNMP trap receivers are configured to receive the alerts.
In the Logs & Monitoring > SNMP page you can do these actions:
n
Turn the SNMP agent on or off
n
Configure SNMP settings (system location, system contact, and community string for SNMP v1 and
v2 authentication)
n
Add SNMP v3 users
n
Configure the settings for SNMP trap receivers
n
Enable or disable SNMP traps that are sent to the trap receivers
SNMP must be set to ON to configure all SNMP settings (users, traps, and trap receivers).
To enable or disable SNMP:
1. Change the SNMP On/Off slider position to ON or OFF.
2. Click Apply.
To configure SNMP settings:
Click Configure.
The Configure SNMP General Settings window opens. You can enable SNMP traps, configure system
location and contact details, and enable SNMP versions in addition to v3.
SNMP v3 Users
n
To add a new SNMP v3 user, click New.
n
To edit an existing SNMP v3 user, select the user from the list and click Edit.
n
To delete an SNMP v3 user, select the user from the list and click Delete.
To Next Page
Loading...
Need help?
General
