Configuring Administrator Access
Quantum Spark 1500, 1600 and 1800 Appliance Series R80.20.40 Locally Managed Administration Guide | 111
Configuring Administrator Access
The Device > Administrator Access page lets you configure the IP addresses and interface sources that
administrators can use to access the Quantum Spark Appliance. You can also configure the Web and SSH
ports.
First set the interface sources from which allowed IP addresses can access the appliance.
To set the interface sources from which administrator access is allowed:
Select one or more of the options:
n
LAN - All internal physical ports
n
Trusted wireless - Wireless networks that are allowed access to the LAN by default (only in Wireless
Network models.)
n
VPN - Uses encrypted traffic through VPN tunnels from a remote site or uses a remote access client
n
Internet - Clear traffic from the Internet (not recommended to allow access from all IP addresses)
To allow administrator access from any IP address:
1. Select the Any IP address option. This option is less secure and not recommended. We recommend
you allow access from the Internet to specific IP addresses only.
2. Change the WEB Port (HTTPS) and/or SSH port if necessary.
3. Click Apply.
An administrator can access the Quantum Spark Appliance using any IP address through the allowed
interface sources.
To allow administrator access from specified IP addresses:
1. Select the Specified IP addresses only option.
2. Click New.
The IP Address Configuration page appears.
3. Select Type:
n
IPv4 address
n
IPv4 network
n
IPv6 address
n
IPv6 network
4. Enter the IP address or click Get IP from My Computer.
5. Click Apply.
The IP address is added to the table.
6. Change the WEB Port (HTTPS) and/or SSH port if necessary.
7. Click Apply.
To Next Page
Loading...
Need help?
General
