Quantum CHECK POINT SPARK 1500 Series User Manual

Managing the Device
Quantum Spark 1500, 1600 and 1800 Appliance Series R80.20.40 Locally Managed Administration Guide | 66
The 'Advanced' tab
For PPPoE
n
IP Address Assignment (PPPoE IPv4 only) - In Local tunnel IP address, select if the IP address is
obtained automatically or manually configured. If manually configured, enter the IP address.
n
Service Provider Settings - In Service, enter a service name (optional) and select the Authentication
method.
n
Connect on demand - Select the Connect on demand checkbox if necessary. This is relevant only
when you are in high availability mode.
For PPTP and L2TP
n
IP Address Assignment -
l
In Local tunnel IP address, select if the IP address is obtained automatically or manually
configured. If manually configured, enter the IP address.
l
In WAN IP assignment, select if the WAN IP address is obtained automatically or manually
configured. If manually configured, enter the IP address, Subnet mask, and Default gateway.
n
Service Provider Settings - In Service, enter a service name (optional) and select the Authentication
method.
n
Connect on demand - Select the Connect on demand checkbox if necessary. This is relevant only
when you are in high availability mode.

Quantum CHECK POINT SPARK 1500 Series Specifications

General

Brand	Quantum
Model	CHECK POINT SPARK 1500 Series
Category	Network Hardware
Language	English