Configuring the Local Network
Quantum Spark 1500, 1600 and 1800 Appliance Series R80.20.40 Locally Managed Administration Guide | 86
Configure the fields in the tabs:
The 'Configuration' tab
n
VPN Tunnel ID - A number identifying the VTI.
n
Peer - The name of the remote VPN site. See
"Configuring VPN Sites" on page233
.
The VPN tunnel interface can be numbered or unnumbered. Select the applicable option:
n
Numbered VTI - You configure a local and remote IP address for a numbered VTI:
l
Local IPv4 address - The IP address to be used for the local point-to-point virtual interface.
l
Remote IP address - The IP address to be used at the peer gateway's point-to-point virtual
interface.
n
Unnumbered VTI - When the VTI is unnumbered, it is not necessary to configure local and remote IP
addresses. You define a local interface to use as the source IP address for outbound traffic.
l
Internet connection - Select from the list.
l
Local bridge interface - Select the local interface from the list.
Virtual Access Point (VAP)
To create/edit a Virtual Access Point (VAP):
See the Device > Wireless Network help page.
The 'DHCP/SLAAC Settings' tab
Note - In IPv4-only mode, this tab is called DHCPv4 Settings.
The values for the DHCP options configured on this tab will be distributed by the DHCP server to the DHCP
clients.
DNS Server Settings (For DHCPv6/SLAAC)
Select one of these options:
n
Auto - Use the DNS configuration of the device.
n
Use the following IP addresses - Enter the first, second and third DNS servers.
DNS Server Settings (For DHCPv4)
These settings are effective only if a DHCPv4 server is enabled.
Select one of these options:
n
Auto - This uses the DNS configuration of the appliance as configured in the Device > DNS and
Device > Internet pages.
n
Use the following IP addresses - Enter the IP addresses for the First DNS server, Second DNS
server, and Third DNS server.
To Next Page
Loading...
Need help?
General
