Configuring Advanced Site to Site Community Settings
Quantum Spark 1500, 1600 and 1800 Appliance Series R80.20.40 Locally Managed Administration Guide | 239
Configuring Advanced Site to Site Community Settings
Note - This page is relevant only if Cloud Services is turned on.
In the VPN > Site to Site Community page you can see details of the community members configured for
this appliance by Cloud Services. The information here is read-only and you cannot update details. The
settings configured by Cloud Services for the VPN > Site to Site software blade are used by the community
members.
The Community page shows:
n
The name of the community configured by the Cloud Services Provider.
n
A table with the sites that are part of the community.
To test the VPN connection for a site:
1. Select the site.
2. Click Test.
If the test succeeds, a success message is shown. Click OK to close it.
If the test does not succeed, click Details for more information. If applicable, click Retry.
To see the details of a site configured by Cloud Services:
Select a site and click View Details.
The View Site Details window opens and shows:
n
Remote site details - Name, host or IP address, authentication method (preshared secret or
certificate), and the Remote Site Encryption Domain
n
Encryption settings - IKE (Phase 1) and IPsec (Phase 2) settings
n
Advanced settings - Encryption method and certificate matching
For descriptions of the fields in the site details tabs, see
"Configuring VPN Sites" on page233
.
To Next Page
Loading...
Need help?
General
