Managing Service Groups
Quantum Spark 1500, 1600 and 1800 Appliance Series R80.20.40 Locally Managed Administration Guide | 270
Managing Service Groups
The Users & Objects > Service Groups page lists the service groups defined in the system. In this page
you can add new service groups, and edit or delete existing service groups.
We recommend you define service groups to configure the security policy. If the security policy is configured
with groups and not specified objects, it is much easier to maintain the policy over time. If you decide to add
new service objects to the system, you only need to add them to the relevant groups and your policy
automatically applies.
There are built in service groups for common services.
Some of these service groups also contain additional configuration for the inspection of the specific protocol.
To create a new service group:
1. Click New.
The New Service Group window opens.
2. Enter a Name for the group and Comments (optional).
3. Click Select to show the full list of available services and select the relevant checkboxes.
4. Click New if the existing list does not contain the services you need. For information on creating a
new service object, see the Users & Objects > Services page.
5. Click Apply.
The New Service Group window opens and shows the services you selected.
6. You can also click New from the New Service Group window.
7. To remove a service object from the group list, select it and click Remove.
8. Click Apply.
The service group is added to the list of groups.
To edit a service group:
1. Select a group from the list.
2. Click Edit.
3. Make the necessary changes.
4. Click Apply.
To delete a service group:
1. Select the group from the list. Note that you can only delete a user defined service group.
2. Click Delete.
3. Click Yes in the confirmation message.
To Next Page
Loading...
Need help?
General
