Configuration and Upgrade Scenarios
Quantum Spark 1500, 1600 and 1800 Appliance Series R80.20.40 Locally Managed Administration Guide | 23
Configuration and Upgrade
Scenarios
This chapter contains workflows for common configuration and upgrade scenarios.
Configuring Cloud Services
Introduction
Cloud Services lets you connect your Quantum Spark.Appliance to a Cloud Services Provider that uses a
Web-based application to manage, configure, and monitor the appliance.
Prerequisites
Before you connect to Cloud Services, make sure you have:
n
Received an email from your Cloud Services Provider that contains an activation link. When you click
the link , your Check Point Appliance automatically connects to Cloud Services.
Or
n
The Service Center IP address, the Quantum Spark Appliance gateway ID, and the registration key.
Use these details to connect manually your Quantum Spark Appliance to Cloud Services.
To automatically connect to Cloud Services:
1. Make sure the Quantum Spark Appliance was configured with the First Time Configuration Wizard.
See the relevant Getting Started Guide.
2. In the email that the Security Gateway owner gets from the Cloud Services Provider, click the
activation link.
After you log in, a window opens and shows the activation details sent in the email.
3. Make sure the details are correct and click Connect.
For more details, see
"Configuring Cloud Services" on page40
.
To connect manually to Cloud Services:
1. In the WebUI, go to the Home > Cloud Services page.
2. Follow the Connect to Cloud Services procedure in
"Configuring Cloud Services" on page40
.
To Next Page
Loading...
Need help?
General
