Setting the Management Mode
Quantum Spark 1500, 1600 and 1800 Appliance Series R80.20.40 Locally Managed Administration Guide | 39
n
To connect to the Security Management Server now, select Connect to the Security
Management Server now, enter the Security Management Server IP or name and click
Connect. When you successfully connect to the Security Management Server, the security
policy is automatically fetched and installed.
If the Security Management Server is deployed behind a 3rd party NAT device, select Always
use this IP address and manually enter the IP address the appliance used to reach the
Security Management Server. This IP address overrides, from this point on, the automatic
calculating mechanism that determines the routeable IP address of the Security Management
Server for each appliance.
If trust was established but the gateway could not fetch the policy, you can investigate the issue
with the Security Management Server administrator. When the issue is resolved, click the
Fetch Policy button that shows instead of the Connect button.
n
To connect to the Security Management Server later, select Connect to the Security
Management Server later.
4. Click Finish.
To reinitialize trusted communication with the Security Management Server:
1. In the Security Management Server section, click Advanced to reinitialize trusted communication.
2. Click Reinitialize Trusted Communication.
A Warning message shows.
3. Click Yes.
Note - You need to coordinate this operation with the Security Management Server administrator, as
reinitialization is necessary on both sides.
Security Policy
To obtain the security policy from the Security Management Server, click Fetch Policy. This option is
available only if trust is established with the Security Management Server.
Internet
To test connectivity, click Test Connection Status. A status message shows the results of the test. You can
click Settings to configure Internet connections.
To Next Page
Loading...
Need help?
General
