Managing Active Devices
Quantum Spark 1500, 1600 and 1800 Appliance Series R80.20.40 Locally Managed Administration Guide | 47
To revoke the Hotspot access:
1. Click the record for the relevant device.
2. Click Revoke Hotspot Access.
The access for that device is revoked. You must log in again through the Hotspot to reconnect the
device to the gateway.
Note - If there is no IPv6 activity in a dual stack host, the Active devices do not show the IPv6 address.
Note - This page is available from the Home and Logs & Monitoring tabs.
To add a new network object and bypass SSL inspection based on the host MAC address (locally
managed only):
1. Click the Device Name > Save as and select Device type Network Object.
2. For Host MAC address, enter a custom value or select from the menu.
3. Select the checkbox for Bypass host with this MAC by SSL inspection.
4. Enter the Object name.
5. Click Apply.
Note - You can also do this from the Users &Objects >Network Objects page. Click New, and then for
Type, select Device.
To Next Page
Loading...
Need help?
General
