Configuring the Routing Table
Quantum Spark 1500, 1600 and 1800 Appliance Series R80.20.40 Locally Managed Administration Guide | 93
n
IP Address - Enter the IP address.
n
Internet connection - Select an internet connection.
n
VPN Tunnel (VTI) - Select the VPN Tunnel.
3. Click OK.
4. Click any source and select an option in the new window that opens:
n
Any
n
Specified IP address - Enter the IP Address and Mask
5. Click any destination and select an option in the new window that opens:
n
Any
n
Specified IP address - Enter the IP Address and Mask
6. Click OK.
7. Click any service and select a service name or enter a service name in the search field. You can
create a new service or service group.
Note - Static routes are not supported for source based or service based routes using VTI (VPN).
8. Optional - Enter a comment.
9. Enter a Metric between 0 and 100. The default is 0.
10. To enable Scope Local, select the checkbox.
11. Click Apply.
To configure a default route:
1. Go to Device > Local Network page.
2. Select an interface and click Edit.
The Edit window opens in the Configuration tab.
3. Click the DHCP Server options tab.
4. In the Default Gateway section, do one of these:
n
Click Use this gateway's IP address as the default gateway.
n
Select Use the following IP address and enter an IP address.
5. Click Apply.
To Next Page
Loading...
Need help?
General
