Radwin 5000 - Page 146

RADWIN5000ConfigurationGuide Release4.9.17 4‐68
ChangingtheSectorBand ManagingtheSector
7. ClickOK.Asectorre‐syncfollows.
Havingsetthechannelbandwidthandoperatingchannelsearlier,thereisnoneed
fordeactivationandreactivation.
YoumayalsoaddnewBandsbyclickingtheAddBandsbutton.Therearesev e ralprovisosto
this:
• AdditionalBandsmustbeavailableforyourhardware
• SuchadditionalBandsmustbeavailablewithintheframeworkofyourlocalregulations
TheforegoingappliestobothregulatedandunregulatedBands.
 Toobtainandinstalladditionalbands:
1. MakealistofODUserialnumbersforallHBSsandallHSUstoreceiveadditional
bands.Thelistshouldbeasimpletextfile,oneserialnumberperline.(Theserial
numbersarelocatedonthestick ersontheODUs.)
2. AsInstaller,openthewindowofFigure 4‐30above,andclickAddBands.The
followinginstructionpanelisdisplayed: