Radwin 5000 - Page 147

RADWIN5000ConfigurationGuide Release4.9.17 4‐69
ChangingtheSectorBand ManagingtheSector
Figure4‐32:AddBandsInstructionsPanel
TheserialnumbersdisplayedrelatetotheODUsinthesector.ClickCopytoClip‐
board.
3. Thisstepappliesonlyifyouhaveadditionalun‐installedunits:
Beforeproceedingtostep2inFigure 4‐32,openyourownlistinaplaintexteditor.If
thedisplayedserialnumbersareinthelist,selectyourlistandcopyitalltotheclip‐
board.Otherwiseappendtheclipboardcontentstoyourlist.Selectthewholelist
andsaveittotheclipboard.
4. Nowcarryoutsteps2to4inFigure 4‐32.Step2willtakeyoutoaWebpage,which
containsaformlikethis: